Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

What if I run out of CTI Ports for CER?

If I have CER and only have 5 CTI Ports configured to alert on-site personnel that an emergency call was made, what would happen if there were 6 simultaneous emergency calls made? Would the CER queue the 6th call and complete it to the appropriate on-site personnel when one of the CTI Ports is freed up or does it get a busy signal and just "drop" the call?

4 REPLIES
Red

Re: What if I run out of CTI Ports for CER?

It will busy. You may configure "Call forwarding when busy" on the RP, so it can route to any destination you want.

Michael

http://htluo.blogspot.com

New Member

Re: What if I run out of CTI Ports for CER?

I understand that a CTI Route Point can be configured with Call Forwarding. So if somebody dials 911 and the CER is down, you can forward the 911 call somewhere else.

However, what about the CTI Port that is configured so that the CER can call the on-site emergency personell when a user dials 911. If I only configure 2 CTI Ports and they are already being used (because 2 people already dialed 911), what would happen if a 3rd person dialed 911. Would the CER queue the call to the 3rd on-site person and call when one of the CTI Ports is freed up or would that call to the 3rd on-site person not get made?

Thanks

Red

Re: What if I run out of CTI Ports for CER?

When you called the RP, the call was actually being routed to the CTI port. When there's no available CTI ports, the RP will ring busy. In this case, the "Call Forward when Busy" would take effect.

Hope that answered your question.

Michael

Hall of Fame Super Silver

Re: What if I run out of CTI Ports for CER?

Why not simply add more cti ports? They cost nothing.

Chris

160
Views
0
Helpful
4
Replies