Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

VIP Super Bronze

When a user presses message button, Unity says message box is full

When a user presses message button on his phone he hears the prompt your message box is full or almost full.

This has been checked and his message box is not full.

Any help please

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: When a user presses message button, Unity says message box i

Hi, this is caused because the storage limits set for these mailboxes, go to AD users and computers and locate the user or the domino person, (if domino integrated), and check what is the storage limits, (exchange general tab -- storage limits), if the user has reached this limit this is the problem, if not you might want to check what the doh tool has to say about this, open the tools depot, go to diagnostic tools, open the dohproptest when it prompts you for the password just click on 'ok' then click on 'ignore' this will open the tool, then on the first column on the left click on 'mailusers' then on the column on the middle locate the affected user, then click on the 'get user's mailbox' button that is below the 3rd column, check the 'limits' area, you are interested on the 'warning' field, if this is not correct then do a full resyc with the DC and GC (you can use the DCGC reconnect setting tool if this is unity 4.0.4 or later, use the 'force reconnect' button, if this is unity 4.0.3 or less use the dohproptest tool, click on the GC and AD or Domino monitor, and do a total resyc.

2 REPLIES
Cisco Employee

Re: When a user presses message button, Unity says message box i

Hi, this is caused because the storage limits set for these mailboxes, go to AD users and computers and locate the user or the domino person, (if domino integrated), and check what is the storage limits, (exchange general tab -- storage limits), if the user has reached this limit this is the problem, if not you might want to check what the doh tool has to say about this, open the tools depot, go to diagnostic tools, open the dohproptest when it prompts you for the password just click on 'ok' then click on 'ignore' this will open the tool, then on the first column on the left click on 'mailusers' then on the column on the middle locate the affected user, then click on the 'get user's mailbox' button that is below the 3rd column, check the 'limits' area, you are interested on the 'warning' field, if this is not correct then do a full resyc with the DC and GC (you can use the DCGC reconnect setting tool if this is unity 4.0.4 or later, use the 'force reconnect' button, if this is unity 4.0.3 or less use the dohproptest tool, click on the GC and AD or Domino monitor, and do a total resyc.

VIP Super Bronze

Re: When a user presses message button, Unity says message box i

Excellent!

This resolved my issue. Exchange was using the deafault store size and warning. After I unchecked this in the users storage kimits, the warning went away.

Thanks

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
140
Views
0
Helpful
2
Replies
CreatePlease to create content