Unified Computing System Discussions

Hi,I have an issue with one of my blade server with the Bios post completion error. The server is hung at the discovery.I have tried reseat the blade, the  tried to recover the corrupt BIOS and it failed.This is a new server and no SP attached. Is th...

Hi guys,We have a UCS220 which seems to keep randomly restarting on us. We only have 1 PSU attached at the minute, but is connected to a UPS and no other devices connected to the UPS are having any problems.The last restart happened today at about 3p...

Hi All,I am having a problem that whenever I restart my Fibre Interconnet, be it restart due to firmware upgrade o anything else, the servers become unreachanble from outside....taking KVM console, when I try to ping the gateway, it can not...only op...

Has anyone else experienced this problem? I had an ECC error yesterday on my B200-M3 blade. The blade recovered properly, but the ESXi (5.1u1) software hung hard.Is anyone aware of any bugs that might cause this problem?Thanks,     -Steve

I have two C220-M3 servers and I am experiencing this on both, so I have to wonder if I'm doing something wrong.  Right now, on both servers, when I boot them to the initial screen "Press <F2> to enter setup, <F6> Boot Menu, <F8> CIMC Config, <F12> N...

Hi everybody,I am confuse software VM-FEX and hardware VM-FEX.Does the software VM-FEX is Emulated mode and hardware VM-FEX is VMdirectpath mode? If i design a VM-FEX, is there must have nexus 1000V or not ?Is  Nexus 1000V and VM-FEX must work togeth...

Is anyone using rancid successfully to backup UCS configuration?If not, which CLI commands should be used to backup all the config?The goals are:Have a full backup of all UCS config.Detect any config change in all system scopes.Yuval

Hello,Is there UCSM CLI Navigator version 2.1 available?ThnaksHetal Soni                  

Good Day All,I am having trouble accessing the CIMC port from the switch.It is on an access-port in the dedicated management vlan.If I connect directly to the CIMC using a cross-over cable, all is fine and I can login to the CIMC via the web browser....

MMNEXUS01# sh int status--------------------------------------------------------------------------------Port          Name               Status    Vlan      Duplex  Speed   Type-------------------------------------------------------------------------...