Unified Computing System Discussions

Hi, I am new to Cisco UCS product.Can anyone explain to me how many servers can I install in Cisco UCS M220 C3? I read the Cisco UCS M220 C3 data sheet, but it didn't state number of servers that can be installed there. Is there any ways to identify ...

Hello,     After upgrading to the 2.1(1a) firmware, I noticed that two of my 8 blades want to boot into this new Configuration Utility after the service profile has been applied. The software just sits at Initializing Kernel forever.Does anyone know ...

Are there any advantage to upgrade from 2.0 (1t) to 2.1 ucsm?

I was wondering what people are doing when creating service profiles for esxi. Are you creating a single service profile for each esxi server you deploy or are you using a template and then creating service profiles from that template?Also what is th...

                   Hi everyone,my client requested me to quote/recommend a ucs server that can do vitrualisation of up 20 vitual machines(VM). Please which model of c-series server can i recommend?please share with me the part number or possibly the ...

Hello, I'm in the middle of my first UCS deployment and I'm having a hard time understanding how to configure a boot from SAN policy that offers HA. The primary SAN boot vHBA is connected to FAB-A and points to the NetApp FC port connected to FAB-A a...

does anyone did ever change the san boot disk to its replicated LUN? i have a requirement  to move my present SAN BOOT lun to the replicated LUN any thoughts how i can achieve this? thanksGGAJULA

HiI have SFP-LH-SM in eth1/1 in Nexus5548UP but I have problem to get LINK on eth1/1.I have SFP-LH-SM in eth1/1 in another Nexus5548P and it is not  problem to get LINK with same configuration of eth1/1Is there some special setting for Nexus5548UP?Is...

I zoned in my wwpn on the fiber switches but the array is not seeing the wwpn. Is there anything that needs to be enabled on the bios of the blade server?Boot orer is cdrom and then san boot

I have a C200 M1 running 1.4(3p), I am noticing some performance issues with this server, it just seems slow.  I went to it physically and you can hear the PSU fans spin up and slow down every few seconds.  Within an SSH to the CIMC I am seeing both ...

Hey,Is this still supported in UCS 2.0 with the new 6100 with "unified ports"?

for each blade, we have 2 vnics assigned to the server. one vnic to fexA and one vnic to fexB. then i create only 1 vswitch and assign both vnics to this vswitch.then all port groups are under this one vswitch.question is it better to create more vni...

Hi,I do not undersand the assigment order for IP pool, Mac @ Pool, WWN pool....Sometime it seems logical :for example : MAC pool 00:25:B5:41:0A:00 to 00:25:B5:41:0A:3F, the server 1_nic1 get 00:25:B5:41:0A:3F, the server 1_nic2 get 00:25:B5:41:0A:2F....