Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2.0(3a) firmware upgrade

I'm trying to upgrade our UCS to 2.0(3a), but when I go to upgrade the IO Modules, the only option I see besides the current 2.0(1s) is 2.0(2q). Should I pick 2.0(2q) or should I see 2.0(3a) as an option?

Thanks,

--Carl

  • Unified Computing
Everyone's tags (3)
4 REPLIES
New Member

Re: 2.0(3a) firmware upgrade

You should see a 2.0(3a) option for the IOMs as well. Have you upgraded anything else, and if so did you see a 2.0(3a) option from the dropdown?

If you very recently uploaded the firmware bundle, it may take a couple of minutes to extract and verify the contents before the firmware will be available to update or activate.

New Member

2.0(3a) firmware upgrade

Yes, I see 2.0(3a) available for everything else. I've had the firmware bundle for a couple of weeks now.

--Carl

New Member

Re: 2.0(3a) firmware upgrade

You might try re-uploading the bundle. I'm guessing the IOM firmware failed an integrity check and was discarded.

New Member

2.0(3a) firmware upgrade

Go to equipment - firmware management - download tasks - Make sure the FSM status for the download is "nop".

other the "nop", it does mean that the download did not occur successfully.

thank you,

AK G

987
Views
0
Helpful
4
Replies