Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2012 service profile, A side working but not B side

I got a 2012R2 service profile that has 4 nics

 

nic 0 goes to vlan 245 on fabA

nic1 fors to vlan 245 on fabB

 

I can get network connectivity on fabA but not on fabB

 

both uplinks on both fabs are up and green

 

both sides have native vlan 245 configured. 

 

any idea?

  • Unified Computing
3 REPLIES
Bronze

Looks like you already have a

Looks like you already have a case open on this - but offhand:  It really depends.  I would assume you have the vlan created and allowed on the trunk/po on each FI and that "show int trunk" on the FI from nxos shows the vlan is up and active. As well, whatever connects to the B side, check the upstream switch port that it connects to for the vlan, and whether its up (on the trunk/po, and spanning tree state). Those are the basics assuming you don't have something else in the config setup incorrectly, or windows is bridging the nics causing spanning tree to clip a link on B.

New Member

now I am not getting any

now I am not getting any connctivity on A but I get it on B

 

on the server, I noticed this

 

 

Bronze

Unpinned would imply that

Unpinned would imply that there is no path out of FI-A. This can happen at any one of many points, i.e. IOM-A in the chassis has a port down, the FI is missing correct configuration to pass the vlan, the configuration is present on the FI (vlan and association to an upstream device) - however, the upstream device is missing the vlan/blocked the vlan.

 

I would login to the FI over SSH and look at "show interface brief" you should see the server listed in the output and the "virtual interface" that is unpinned. Issue "show interface vif XXX" and look at the reason it thinks it is down. As well, show vlan, show int trunk to verify that the vlan is assigned and operational on at least 1 network link. 

30
Views
0
Helpful
3
Replies