if we want to manage a C200 by a 6200 via a 2232, do we always need to connect both the 1Gbe and 10Gbe interface?
In our existing C200 we don't have any VIC's and both cards are connected to some other network, so we only want to connect the 1Gbe ILO interface to the 2232 for management, is that a supported/working setup.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...