Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

C220M3 LSI Storaged Raid Subsystem not ready yet 9271-8i

New C220M3 with 9271-8i out of box with 2.0.1b firmware

Control H doesn't boot into WebBios, instead I get EFI Shell with map:cannot find required map name.

Press ESC in 1 seconds to skip startup.nsh, any other key to continue

 

From the CIMC I select 2 drives to create a drive group and it fails with message;

Error: Storage Raid subsystem not ready yet

 

See screenshot;

 

  • Unified Computing
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Make sure the optionROM for

Make sure the optionROM for the raid controller is enable in the bios. 

 

1)Reboot server

2)Press F2 when you see the option to go into bios

3)go to advance 

4)select the last option here I believe it is LOM and PCIe

5) verify that in slot 2 the optionROM is loaded

3 REPLIES
Cisco Employee

Make sure the optionROM for

Make sure the optionROM for the raid controller is enable in the bios. 

 

1)Reboot server

2)Press F2 when you see the option to go into bios

3)go to advance 

4)select the last option here I believe it is LOM and PCIe

5) verify that in slot 2 the optionROM is loaded

Thank you for provide this

Thank you for provide this solution. It fixed my issue. (BIOS not recognizing LSI RAID Controller)

New Member

By restarting CIMC it worked

By restarting CIMC it worked from me because above configuration is already in place as suggested.

2574
Views
15
Helpful
3
Replies
This widget could not be displayed.