We have 11 digit DN's. Users are used to dialing and see'ing 6 digits. I have used transformation patterns so that when someone is called, the person called see's the call as just the last 6 digits. However, the person who dialed 6 digits sees the entire 11 digit number.
Is there anyway to make it so the person who placed the call only see's the last 6 digits?
I am not a call manager expert, but I know that this possible as when we dial 11 digits here for a company number on another campus the system will automaticly change the calling party number on the phone display.
I think you would get a better response from the following comunities:
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...