With old nexus 1000v version default limit was 32 If you have upgraded software this limit ramains the same with new software. you have to mannually set max-port 64 under port profile. If you set default max port count to 64 then it will not make any chages to exisitng port profile but new port profile created will have max port set to 64. For all this to work you need to have active SVS connection with your vcenter. You can see change on vcenter under Home - inventory - networking and select port profile and see how many total port available
Moquery is the command line cousin of Vizore, it's very helpful and efficient sometimes during the troubleshooting. This article aims to provide moquery cheat sheet to the users for some most common seen scenarios.
Here is the checklist before customers/partners contact Cisco TAC:
Firmware Version of APIC and Switch
Download Switch and APIC techsupport logs
Problem description (Symptoms with details)
Business impact (eg, what kind of services...
moquery usageAPIC moquerySwitchmoquery
This document discuss a common issue observed during the VMM integration & VM workload migration to ACI fabric.
VMware Virtual machines are hosted in Cisco UCS-B seri...