Cannot ping my laptop from the blades within the UCS chassis
Am building a lab setup now that we have our Vblocks up. We need to be able to ping back to the laptop that is in the same network and something is stopping us. We have done the following - opened up a case with Cisco - a case with Vmware - we cannot get the network (although it is completely flat) to allow port 902 through to the laptop. I can ping between the blades via the ESXi local prompts. We are booting from the san, there is NO vlan as this is just a lab and the network has only the devices for this lab. A 5020, 9124, Nexsan, 6120, 5108 and 8 blades with ESXi 4.1 installed on 6 of them.
I can ping the 5020 and all the other servers - but not back to my laptop so therefore cannot get to the esxi via the vi client to build the vms I need nor to update the firmware.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...