Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco 6100 fabric A is configured as cluster, Fabric B configured as standalone

Cisco UCS 6100 fabric A is configured as cluster (only one member), Fabric B configured as standalone

How can I add fabric B to cluster environment. Inicial setup is no longer avaialbale? any cli command avaialbale that I can use?

Thanks

1 REPLY

Cisco 6100 fabric A is configured as cluster, Fabric B configure

Assuming you aren't using fabric interconnect B for production hosts you can SSH or console in and run these command to reset to factory defeaults, keep in mind that this will erase all config from fabric B.

connect local-mgmt

erase configuration

switch will reboot and come up to the initial setup prompts

346
Views
0
Helpful
1
Replies
CreatePlease to create content