Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco UCS and VNX Initiators

I am installing a new UCS blade system connecting it to a VNX5300 at our disaster recovery site. We are installing ESXi 5.0 Update 2 on each blade using boot from SAN. I have created my service profile and associated it with a blade. The profile has two SAN boot targets pointing at 2 different WWNs corresponding to ports on SPA and SPB. They are configured as a primary and secondary.

When the blade boots I have to manually register the first initiator that connects and assign it to the proper storage group so that my server will continue to boot and install ESXi. During this process I only have one of the two SAN boot targets configured. I also have assigned 4 vHBAs to the profile. After I get the blade set up with ESXi I then go in and add the secondary SAN boot target.

My problem is this....

When I look at the initiators on the VNX I see 5 initiators instead of the 4 I would expect.

Example: I have A-4, A-5, B-4 and B-5 wired on the VNX. I have assigned the SAN boot targets to A-4 and B-4. I would expect to see 4 initiators (2 that point to one of the A-X and 2 that point to the B-X). What I am seeing is 4 initiators that follow this pattern and one initiator that is duplicated and points to A-4 and B-4. Looking at the initiators it seems that the duplicate initiator that points at B-4 is erroneous.

Why am I seeing this happen?

Thanks.

Everyone's tags (3)
4 REPLIES

Cisco UCS and VNX Initiators

Which storage switches are you using?

If MDS, which VSANs are you using?

This could point to a zoning issue where you zoned the same WWPN of one initiator to both A and B SPs. 

Robert

New Member

Cisco UCS and VNX Initiators

I'm using zoning on the fabric interconnects.

Re: Cisco UCS and VNX Initiators

An important detail .  Which version of UCSM?

Also provide your zoning config:

connect nxos a

show zone

exit

connect nxos b

show zone

Thanks,

Robert

New Member

Re: Cisco UCS and VNX Initiators

Yeah sorry I didn't mention that in my original post. Running UCSM 2.1(1d). Here's the zone config.

939
Views
0
Helpful
4
Replies