I'm new to Cisco servers and need some assistance. We are going to be deploying 200 to 300 C220 servers for one of our customers. I'm looking for a way to set the BIOS and Raid configuration during a Microsoft MDT LiteTouch task sequence. I think I have the BIOS figured out by using the Cisco UCS Server Configuration Utility but I've been unable to unveil a way to configure the RAID in my research.
I need to know if I will be able to configure the BIOS and RAID via command line in a winpe environment and if so, which tools do I need.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...