Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco UCS C22 M3 Setup Error

We are setting up Windows Server 2008 R2 (64bit) on a new Cisco UCS C22 M3 server. We followed the Cisco guide to install a new Hard Disk in the new server and created virtual HDD( Array 0).


We have also downloaded and installed the recommemded storage drivers.

Unfortunately, the created virtual HDD is not available both the CIMC (Under Storage) and during Windows OS installation. Attached are screenshots of the issues identified.

Advice please? Thanks.


Cisco Employee

Hello,Do you see the VD from


Do you see the VD from the webbios? its better to have a TAC case raised with cisco to investigate else you could follow the document below to check the webios settings





Cisco Employee

Hi Michael You need to load

Hi Michael 

You need to load the drivers, to do this you need to click in load drivers. You will see this option on the second screen you posted.  You then have to load the ISO file that can be downloaded using the link below. To load the ISO you have to unmapped the OS ISO and map the drivers, once you map the ISO you will be able to look for the drivers by clicking on the browse button.  Since you are using the embedded raid controller, you need to load the drivers inside the intel folder

File path is 


once you load the drivers make sure to map the OS ISO again in the KVM and click refresh during the install!pp

CreatePlease to create content