Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Controller ID: 0 Controller encountered a fatal error and was reset

Hey all,

I have a Cisco C240 M3S that I will be utilizing as an MS Exchange Server with MS Server 2012 Std Edition.  I am performing stress testing currently on the server and constantly receiving the following error:

     "Controller ID: 0 Controller encountered a fatal error and was reset"

This is an LSI 9266-8I controller card that is being used.

The following is the driver\firmware versions for the controller card on Server:

    

     Firmware - 23.9.0-0023

     Driver - 6.504.4.0

I don't believe it is a driver\firmware issue as I have another machine identically configured and not experiencing any issues.  The CMIC shows everything in a health state, but this is consistently popping up as a Critical error through the MSM software. 

Any ideas, I will be getting the controller card replaced, but just curious if anyone has any additional recommendations?

Thanks,

1 REPLY

Controller ID: 0 Controller encountered a fatal error and was re

Justin,

Please open a TAC case, if there is not one opened already.  This condition is being investigated under

CSCuh94185(internal)

-Kenny

3474
Views
0
Helpful
1
Replies
CreatePlease login to create content