I am having issues with discovering my UCS 5108 fabrics in DCNM. I am using DCNM version 6.1 and I have my SNMP V3 information all set up correctly but when I try to do a shallow discovery it just end up timing out. Both the UCS fabrics and the DCNM are both on the same subnet as well. Not sure why I am having such an issue.
Any help of troubleshooting steps I should take to see what is going on.
Are there any Data Center Network Management Guru's out there
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...