Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

ESX host not rebooting on 250-M2 Blades

I have some new 250-M2 blades that I have installed ESX 4 update 1 (also tried update 2) that will not reboot. It gets to the point where it stops all services and unmounts files system and just sits there at the prompt

"please stand by while rebooting the system"

The M1 blades reboot fine.

Anyone know what this could be? A BIOS setting maybe?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ESX host not rebooting on 250-M2 Blades

Have you tried to reset the blade CMOS?  Ensure they're running the defaults to rule out any settings potentially causing an issue.

Robert

2 REPLIES
Cisco Employee

Re: ESX host not rebooting on 250-M2 Blades

Have you tried to reset the blade CMOS?  Ensure they're running the defaults to rule out any settings potentially causing an issue.

Robert

Re: ESX host not rebooting on 250-M2 Blades

That fixed it, thanks.

803
Views
0
Helpful
2
Replies
CreatePlease to create content