ESXi vmnics connected at 20000Mb when expecting 40000Mb
Hi all, I've got 4 x B200M3 blades running ESXi 5u2 in a single UCS chassis. These run a number of vSwitches, and all of the connected vmnics show 40000 Mb full duplex (as expected). Yesterday I added 2 more B200M3's (to slot 7 and 8), and I'm only getting 20000 Mb on all vmnics. The the hosts are configured the same as the old via vCenter (although not using Host Profiles), and the UCS Service Profiles on the new blades are clones from an existing blade.
See screenshots attached....
Does anyone have some idea of what that could be? Any assistance would be great.
You're spot on manvelas - didn't think to check, but our supplier missed the additional mezz card on these 2 units. The part we're missing to allow 40gb is: Cisco UCS Port Expander Card (mezz) for VIC 1240 modular LOM (Cisco part: UCSB-MLOM-PT-01)
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...