Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

F1237 Error

Ok, I recently upgrade my two production UCS system to 2.1.2a and now I'm gettting this F1237 error, (voltage threshold cross) on two of my servers blades.  There doesn't seem to be much info on this error ... anyone have some insight?

Thanks,

Cy.                  

4 REPLIES
Cisco Employee

F1237 Error

Hello Cy,

Can you please share complete fault message ?

Padma

F1237 Error

Cy,

Another way to verify what sensors are within the threshold, is by doing the following through a SSH session:

connect cimc x/y     x = chassis  y=server

sensors    <<< The list is big, you may want to make sure the SSH will allow you to scroll back to check them all.

After you see what sensor is not within the normal range, you can share the sensor ID and we can tell you what it is.

If nothing is out of range, we might need you to open a TAC case to see if there is any known behavior affecting the blades after the upgrade.

-Rate all helpful answers.

-Kenny

New Member

F1237 Error

New Member

Do you see F1237 in that

Do you see F1237 in that provided link?  I completely agree that it woudl be helpful for Cisco to adequately document their products.  However I don't see how this link could be considered "Helpful"

2306
Views
0
Helpful
4
Replies
CreatePlease to create content