Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Failed Download Task in UCS

I have been attempting to download new UCS firmware version into my UCS Fabric Interconnect using FileZilla and I keep getting the error '550 File not found' see sreen capture below. What could be the issue??

Failed Download Task in UCS.jpg

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Failed Download Task in UCS

from the filezilla log you are attempting to download 'F:ftproot/ucsb' from the FTP root directory and this is invalid.

Try leaving the path blank in the UCS, and placing the file in the root directory of the FTP server and entering only the filename and IP into the UCS.

Also TFTPd32 is much simpler if you don't need FTP, the only configuration possible in TFTPd32 is root directory and IP address.

4 REPLIES
Cisco Employee

Failed Download Task in UCS

As per the Filezilla error log looks like it can't find the filename you've specified in the UCSM download task.

Check your path & filename (including extension).

Might want to upload the new firmware via Local Browse rather than FTP (requires UCSM 1.4 or later).

Regards,

Robert

New Member

Failed Download Task in UCS

Hi Robert,

Thank you for the reply. I am using UCSM 1.3, that's why I have to use FTP. I have checked the path & filename but still success.

Cisco Employee

Re: Failed Download Task in UCS

from the filezilla log you are attempting to download 'F:ftproot/ucsb' from the FTP root directory and this is invalid.

Try leaving the path blank in the UCS, and placing the file in the root directory of the FTP server and entering only the filename and IP into the UCS.

Also TFTPd32 is much simpler if you don't need FTP, the only configuration possible in TFTPd32 is root directory and IP address.

New Member

Re: Failed Download Task in UCS

Hi chaausti,

Thanks. It worked..by leaving the Remote path blank. Thank you once again and thank you Robert Burns.

441
Views
0
Helpful
4
Replies
CreatePlease to create content