Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

FI's uplink ports Error Disabled on ENM loop

Hi,

I have two UCS6120XP FIs connected to a Cat2948G-GE-TX switch via port 1/3 on each FI. One port on the Cat2948G-GE-TX acts as the uplink port and is connected to the LAN. All ports of the Cat2948G-GE-TX are in VLAN 1 to allow all connected devices to reach the Gateway via the LAN uplink port.

Now after a while both ports 1/3 on the FIs get error disabled on ENM loop.

'show cdp neighbor' on the Cat2k shows FIs hanging off of 2/45 & 2/46. The management ports of both FIs are connected to ports 2/1 and 2/2 of the

Cat2948G-GE-TX as well, as are some other devices.

I'd like to keep both FI uplink ports enabled for failover scenarios - how can I achieve that w/o the ports getting error-disabled?

Thanks,

Matthias

Everyone's tags (4)
749
Views
0
Helpful
0
Replies
CreatePlease login to create content