We were supporting multiple FC fabrics and so need PIN groups to route the appropriate switches based on the physical cabling. We have now retired the old fabric and have all the FC uplink ports going to same set of switches.
All the vHBAs are using PIN groups. Is there a reasonable way to back out of using PIN groups? Should I remove a group of vHBAs from a few ports and then delete the PIN group so I can start moving vHBAs to dynamic pinning?
So UCSM will dynamically assign to an FC uplink port even if all the FC uplinks are currently assigned to a PIN group? I'll try that on a couple of vHBAs since all my servers have at least two ports. thanks
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...