We've had a few cases coming in regarding this issue so figured we'd post it here for visibility.
If the default gateways field is left blank in the iSCSI Boot Parameters, Windows hosts may be unable to find the LUN & Boot properly. During POST, Cisco VIC option ROM will be able to see the LUN, however during OS boot time, Windows is unable.
UCSM 2.0(1) and onward.
Cisco VIC configured for iSCSI boot
Windows Server 2008
iSCSI Initiator & target IP are in same L2 subnet.
Set the Target Array’s IP as the default gateway of the iSCSI Parameters.
Cisco is Tracking this bug under: CSCub65484. We’re currently working with Microsoft on a fix, no ETA yet but this post will be updated when resolved.
Release notes and Windows Installation Guides are being updated next week.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...