Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How get the system clock synced?

I messed up the clock sync, because I specified ntp-clock. At the moment the clock is 10 min faster on FI-B (Show clock). I assume this is why I no longer can log into UCSM?

I have rebooted both the FIs, but the clock is still different on the FI-B.

Doing this, does not help:

UCS-A# scope systemUCS-A /system # scope servicesUCS-A /system/services # set clock apr 14 2010 15 27 00UCS-A /system/services # 

Message was edited by: Atle Dale at 13:36

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

How get the system clock synced?

Hi Atle,

go ahead and open up a TAC case and we'll take a look at it from there.

./Abhinav

5 REPLIES
Community Member

How get the system clock synced?

this is status now. I hope this is not going to cause problems later, or is causing the other problems I do have:

FI6120XP-B(local-mgmt)# show clock

Thu Aug  9 13:41:18 CEST 2012

FI6120XP-B(local-mgmt)#

FI6120XP-B(local-mgmt)#

FI6120XP-B(local-mgmt)# show clock

Thu Aug  9 13:43:06 CEST 2012

FI6120XP-B(local-mgmt)#

FI6120XP-A /system/services # end

FI6120XP-A# show clock

Thu Aug  9 14:34:05 CEST 2012

Silver

How get the system clock synced?

Hi Atle,

go ahead and open up a TAC case and we'll take a look at it from there.

./Abhinav

Community Member

Re: How get the system clock synced?

Unfortunately, my account is not set up for this yet. But I really want to start upgrading firmware today. Can I start with this still?

Community Member

Re: How get the system clock synced?

status: I enabled NTP again and this almost solved the problem. The time is now correct on FI-A in the right timezone, but the the time is 10 min too fast on FI-B.

Community Member

Re: How get the system clock synced?

this can be closed orset as "Answered". I coul dnot delete it or mark it as "Answered" myself. The reason for this problem was that the FI-B was connected with mgmt1 port.

444
Views
0
Helpful
5
Replies
CreatePlease to create content