Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

How to reload/reset 6100/Fiber Interconnect from the CLI?

Hi there,

there is no reload or reboot command on the 61000 (in CLI) ?!? I'll also appreciate answer how to do it from GUI.  Another similar question, obviously from a newbie, is related to missing "write" commad: does it mean that every accepted command is automatically written in NVRAM?

Regards,

Tenaro

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: How to reload/reset 6100/Fiber Interconnect from the CLI?

Tenaro,

You certainly can reboot an FI from the CLI.

From the UCSM CLI:

connect local-management

reboot

Also, when making changes to UCSM from the CLI you may noticed that your prompt will add an astericks "*" to the end.  This means you have commands awaiting to be committed to the system.  If you wish to "save" / "commit" your changes you just enter:

commit-buffer

or

discard-buffer

Ex.

UCS-A# scope service-profile server 2/2

UCS-A /org/service-profile # scope boot-definition
UCS-A /org/service-profile # create boot-definition
UCS-A /org/service-profile/boot-definition* # commit-buffer

Regards,

Robert

1 REPLY
Cisco Employee

Re: How to reload/reset 6100/Fiber Interconnect from the CLI?

Tenaro,

You certainly can reboot an FI from the CLI.

From the UCSM CLI:

connect local-management

reboot

Also, when making changes to UCSM from the CLI you may noticed that your prompt will add an astericks "*" to the end.  This means you have commands awaiting to be committed to the system.  If you wish to "save" / "commit" your changes you just enter:

commit-buffer

or

discard-buffer

Ex.

UCS-A# scope service-profile server 2/2

UCS-A /org/service-profile # scope boot-definition
UCS-A /org/service-profile # create boot-definition
UCS-A /org/service-profile/boot-definition* # commit-buffer

Regards,

Robert

827
Views
0
Helpful
1
Replies