Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to verify ucs uptime?

Hi All,

 

I observed UCS alert on my monitoring tool.

 

Service : System Uptime 
State : OK 
Hostgroup: Switch 
Time: Tue Apr 15 19:10:16 UTC 2014 
Additional Info: OK: UPTIME=34 minutes, 11.37

 

But when I logged in and verified the system uptime, it was up from a very long time:

System start time:          Thu Nov 29 19:17:30 2012
System uptime:              501 days, 18 hours, 46 minutes, 45 seconds
Kernel uptime:              501 days, 19 hours, 25 minutes, 11 seconds
Active supervisor uptime:   501 days, 18 hours, 46 minutes, 45 seconds

 

Could you please explain any other command to verify uptime?

 

Thank You,

Phani.

 

 

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

First you need to find out

First you need to find out what is the ip address of each fabric, if you don't know what they are you can log into UCSM (see screenshot attracted )

Once you have the ip for both fabrics, SSH to the IPs and and run the following commands to get the uptime on each fabric.

F-A# connect nxos

F-A(nxos)# show system uptime

 

 

3 REPLIES
Cisco Employee

Hi phani.raju,Did you verify

Hi

Did you verify the uptime for both UCS fabric interconects? 

It might be that one of the fabrics rebooted, ssh to the IP address of both the primary and secondary fabric interconnect and check the uptime.

New Member

@manvelas,Could you please

@manvelas,

Could you please let us know command to verify the uptime from fabric interconnect.

 

Thank You,

Cisco Employee

First you need to find out

First you need to find out what is the ip address of each fabric, if you don't know what they are you can log into UCSM (see screenshot attracted )

Once you have the ip for both fabrics, SSH to the IPs and and run the following commands to get the uptime on each fabric.

F-A# connect nxos

F-A(nxos)# show system uptime

 

 

3501
Views
0
Helpful
3
Replies