Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is it possible to change the port-channel load balancing policy on the FIs?

We currently have a 2 member port-channel from each of our 6248s up to a 6500, with src-dest IP load-balancing policy set on each side. We're running into an issue where 2 particularly busy servers are getting hashed to a single PC member, and that member is running at full utilization. I'd like to test with L4 balancing, but don't see where that policy can be set in the CLI. Anyone know if this is possible?

1 REPLY
Cisco Employee

Is it possible to change the port-channel load balancing policy

Brad,

I don't think FI supports L4 load balancing on ethernet uplink port-channels.

6248-01-B(nxos)# sh port-channel load-balance

Port Channel Load-Balancing Configuration:

System: source-dest-ip

Port Channel Load-Balancing Addresses Used Per-Protocol:

Non-IP: source-dest-mac

IP: source-dest-ip source-dest-mac

Padma

367
Views
0
Helpful
1
Replies