cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
693
Views
0
Helpful
3
Replies

Is NAM license required for Nexus 1010 Standby Node?

chuapk_1973
Level 1
Level 1

Hi, need some expert advice here.

My client has a Nexus 1010 currently. It is loaded with Cisco NAM Virtual Service Blade Software 4.2.

Recently, they have decided to purchase another Nexus 1010 as a standby node.

My key question is do they have to purchase another Cisco NAM license for the standby node?

The reason is when I'd tried to configure a Nexus 1010 HA pair, the BOM generated is only a single NAM license for the pair.

Now I need to configure a single N1010 as standby node. The NAM license is available in the configuration, I'm not sure if I should included the NAM license in the BOM.

Thanks.

3 Replies 3

padramas
Cisco Employee
Cisco Employee

Vincent,

NAM does not have HA functionality. So, if you want to have NAM redundancy, you can install a standalone NAM on secondary Nexus 1010  and have same exact configuration as of the NAM in primary Nexus 1010.

Each NAM installation requires separate license as it is locked with HW appliance.

http://www.cisco.com/en/US/partner/docs/net_mgmt/network_analysis_module_virtual_blade/4.2/install/guide/nexus/nx42ov.html#wp1055429

" show virtual-service-blade summary"  would list both NAMs as primary.

HTH

Padma

Both Nexus 1010 and Nexus 1010-X support a maximum of 1 non-HA NAM.  While multiple NAMs can be deployed it is technically not supported.

http://www.cisco.com/en/US/docs/switches/datacenter/nexus1000/sw/4_2_1_s_p_1_3/release/notes/n1010_rn.html#wp63955

Matthew

chuapk_1973
Level 1
Level 1

I see. So in our case, I guess I need not include a NAM license in the Standby node. Since only 1 NAM supported.

Thanks Matt and Padma...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: