The L1/L2 ports are for clustering two 6100's together. Use a regular Cat5 cable to connect the L1 on switch1 to the L1 port on switch2 and do the same with the L2 ports. Then console to the first switch and run through the setup dialogue. If the L1/L2 ports are connected properly when configuring the second switch you can set it up as a secondary and the clustering will be automatically configured.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...