I want to do practice on cucm, gateway & gatekeeper through lab enviroment. Please give me some kind of scenario to create lab . I want practice on data & voice enviroment kind of thing through data vlan & voice vlan. I have following device for practice
1 cisco router 3600
1 cisco router 2501
1 L3 switch HP procurve 24 port
3 L2 switch hp procurve 24 port
1 broadband connetion
2 laptop with good configuration
cucm 7 iso
softphone (sip based)
please suggest me any kind of network design (voice & data) according to available metiral with me so that I can start practice.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...