We just received two UCS C200 M1 systems with 4GB (2 DIMMS) each. Whenever we boot either system, the memory fault and system fault lights come on. The CIMC log says that there is a moderate fault, but none of the internal memory fault lights are on.I have tried a few different configurations as far as which slots the DIMMS are installed in, but always get the same result.
When I log into the system, it shows the correct amount of memory and seems to be functioning correctly.
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...