Yes in the Data Sheet of the UCS-C250 rack server it mentions the ability to deploy a choice of 2x Raid controller, but using the Cisco configuration tool, you are only allowed to select 1 Raid controller and only 1 type of hard disk. It would be really expensive to get the UCS-C250 for $15K (base price) list only because it supports a dual raid configuration. This really make it hard to compete with other server vendors that offer this feature on there low end server systems.
Thank you for your response and support, i just have one more inquiry about this matters, can the UCS C-Series Rack servers be populated with different hard disk types at the same time, or example 2x 76G 15K and 3x 300G 10K on the same UCS C210 server?
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...