Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Nexus 1010 HA Failover Issue

We have a pair of Nexus 1010's configured in a Standby/Active setup.

We noticed yesterday, that the Active 1010 had failed over to the second 1010.

From the CLI on the Active 1010, there was only 1 1010 running.

We were able to connect to the first 1010 via its cimc interface & could not see any errors.

There is nothing in the logs, except to say that a failover occured (no reason mentioned).

The interfaces on the LAN switch connecting to the 1010 were all up.

A power cycle of the first 1010 has brought it back into HA Standby & we can see both from the CLI.

Has anyone experienced this issue?

We are running

kickstart: version 4.2(1)SP1(3)

  system:    version 4.2(1)SP1(3)

                  

Thanks

Colin

360
Views
0
Helpful
0
Replies