Nexus 5k Needs to be rebooted whenever I restart FI..
I am having a problem that whenever I restart my Fibre Interconnet, be it restart due to firmware upgrade o anything else, the servers become unreachanble from outside....taking KVM console, when I try to ping the gateway, it can not...only option that works for me is restarting my Nexus 5k which in my scenarion works a s a L2 switch...
to brief, I am using Cisco 3750 for creating VLAN (SVI) for servers...then it is connected to Nexus 5k and after that Fibre Interconnect and finallhy UCS 5108 chassis...
Does anyone has any idea, is there any best practice to restart Fibre Interconnect
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...