Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nexus5548P and ESxi communication issue

Hi Guys,

I have a Cisco C210M2 server connected to the nexus switch directly. 2 ports are configured for port channeling and vpc.

On the Server I installed ESXi and created a vSwitch and a host with an IP of 192.168.90.210

I have a storage connected to the pair of Nx switch and configured for PC and vPC. On the storage I have configured the IP on the same range

192.168.90.200

I was not able to ping between the IP address. I have checked that the portchannel is up and runing and vPC status shows as up.

Baically not a networkin guy, I googled a lot and came across lldp.

If I did a sh lldp entry , I can see the storge ports there not the server ports.

On the sh lldp dcbx interface eth1/xx I cannot see any peer information , where as on the other ports I can see the peer information.

The server ports are 1G ports and I configured the speed to 1000 on the nexus , where as the storage ports and 10G.

Any help wil be appreciated, I can provide more details if required.

George

Everyone's tags (1)
1 REPLY
Cisco Employee

Nexus5548P and ESxi communication issue

George,

Can you verify the VLAN configuration on switch interfaces and ESXi host ?

SSH into ESXi host and provide the output of  " esxcfg-vswitch -l "

From N5K switch,

sh run int port-channel ID

Padma

282
Views
0
Helpful
1
Replies
CreatePlease login to create content