Why does UCS not send call home alert emails if all LAN or SAN uplinks fail to a fabric interconnect?
Today while testing multipathing and network redundancy, we disconnected all LAN and SAN uplinks from a fabric interconnect in a HA cluster. 60-some major faults appeared in UCS manager, but no emails were sent even though the full_txt profile was set to severity level Normal.
System inventory emails work fine so the SMTP configuration and recipients are correct.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...