Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

No link between IOM port 2/2/3 and fabric interconnect B

Hello

I am trying to remove an uplink from an IOM to the fabric interconnect as its not required.  I have tried to reset the I/O module and re-acknowledge the chassis with no luck, it is still shown in the GUI with the error message as in the subject.  We are currently running 2.0(1s).  The kit isn't in production yet.

Thanks for any help

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

No link between IOM port 2/2/3 and fabric interconnect B

Hi barry,

The only way for you to clean that up will be to de-comission the chassis in question and re-add it back.

Thanks!

./Abhinav

3 REPLIES
Silver

No link between IOM port 2/2/3 and fabric interconnect B

Hi barry,

The only way for you to clean that up will be to de-comission the chassis in question and re-add it back.

Thanks!

./Abhinav

Community Member

No link between IOM port 2/2/3 and fabric interconnect B

Excellent, thanks for that.  It seems a pretty heavy handed approach to clean that up.  If that config was left, would it cause issues...apart from the error message?

Thanks again

Silver

No link between IOM port 2/2/3 and fabric interconnect B

Yes i agress thats a pretty heavy approach to clean it. No if you left it there as it is, there would have been no operational issues. It would have just left this fault in the UCSM.

./Abhinav

644
Views
0
Helpful
3
Replies
CreatePlease to create content