Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Not Actived chassis "CHASSIS-LIMIT-EXCEEDED"

Hi to all,

we have an infrastructure with two Fabric Interconnect Cisco UCS 6120, the release installed is 1.2(1d), at this moment we have connected 12 chassis UCS 5108 with 1-Link in "Chassis Discovery Policy", so we have 12 Server port configured and we have installed all the required license-port on each fabric interconnect.

We have running the release 1.2(1d) which support up to 12 chassis, but we can not activate more than 10 chassis, in the UCS Manager appear this message "CHASSIS-LIMIT-EXCEEDED".

Someone can help us.

Thanks, bye

Marco Pagani

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Not Actived chassis "CHASSIS-LIMIT-EXCEEDED"

In 1.2(1d) the UCS didn't support more than 10 chassis. To support more, the UCS will need to be upgraded to 1.3(1c) or higher.

Hope that helps.

Thanks,
Michael

2 REPLIES
Cisco Employee

Re: Not Actived chassis "CHASSIS-LIMIT-EXCEEDED"

In 1.2(1d) the UCS didn't support more than 10 chassis. To support more, the UCS will need to be upgraded to 1.3(1c) or higher.

Hope that helps.

Thanks,
Michael

New Member

Re: Not Actived chassis "CHASSIS-LIMIT-EXCEEDED"

Thank you Michael,

We have contacted the TAC Engineer who told us to do the upgrade to version 1.3(1o) just released.

Thanks for your help

Bye

Marco

489
Views
0
Helpful
2
Replies