I have a large ucsm 2.0(3c) infrastructure utilizing VMware 5.0 auto deploy.
Need to upgrade to 2.2(1d) and VMware 5.5 u1 still using auto deploy.
Any thoughts/documents on order of upgrade? Some of the components I am using: 6248 fi's, vCenter, esx, srm, heartbeat, ibm svc sra, fnic & enic driver with cisco custom image for auto deploy, ibm svc fiber channel san, b200 m3 vic 1240, b440 m2 vic 1280.
I was thinking the order would go:
ucsm fi firmware
blade firmware one at a time along with new VMware image at re-boot. New fnic & enic driver as well.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...