Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

portchannle in UCS any idea about the solution

we create a Portchannel in the UCS but it show up in the switch and in the UCS show failed

since no operatioma member f0727 with this error ??

<faultInst

ack="no"

cause="membership-down"

changeSet=""

code="F0727"

created="2012-01-30T10:25:46"

descr="lan Member 1/19 of Port-Channel 10 on fabric interconnect B is down, membership: individual"

dn="fabric/lan/B/pc-10/ep-slot-1-port-19/fault-F0727"

highestSeverity="major"

id="41644"

lastTransition="2012-01-30T10:25:46"

lc=""

occur="1"

origSeverity="major"

prevSeverity="major"

rule="fabric-eth-lan-pc-ep-down"

severity="major"

status="created"

tags="network,server"

type="network">

</faultInst>

1 ACCEPTED SOLUTION

Accepted Solutions

portchannle in UCS any idea about the solution

No.  LACP is the only channeling option.

Regards,

Robert

5 REPLIES

portchannle in UCS any idea about the solution

Mohammed,

There appears to be an issue with the Port Channel negociation.  UCS FI intefaces can only negociate LACP Port channels, so ensure your upstream switch supports and is configured for LACP (802.3ad). 

Once you double check/fix this, disable the Port Channel and then re-enable it. 

If you're unsure, post the interface configuration of the upstream switch(es).

Regards,

Robert

New Member

portchannle in UCS any idea about the solution

I think they use the nonegotiation mode in the upstream switch it not supported ??

portchannle in UCS any idea about the solution

No.  LACP is the only channeling option.

Regards,

Robert

New Member

portchannle in UCS any idea about the solution

becuase of that the portchannel in the upstream switch shows SU

I will try to give you the configuration withen 3 hours from now thanks

New Member

portchannle in UCS any idea about the solution

thaks

also I saw an issue in the chassis 1 as major post faluire error I think due to fan error is that possible

2033
Views
0
Helpful
5
Replies