Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

power-on server on link FI<->FEX activation

Hello all,

To test fault policy (https://supportforums.cisco.com/message/3990962#3990962), I disabled one port of a port-channel between FEX and FI and enabled it.

On the chassis of this FEX, I had a blade associate to a SP but stopped. When the port was enabled, the blade started !!!

When I check the FSM server, there is a "Power-on server" sequence for all servers of this chassis. For servers already started, it was transparent, but not for the stopped server.

Have you an explanation ?

Stéphane

109
Views
0
Helpful
0
Replies