Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem with booting to VMware ESXi 5.0

I just installed VMware ESXi 5.0 on a new Cisco UCS B200 series blade with two 300 GB hard drives configured in a RAID 1 Mirrored.  I went through and completed installation of VMware ESXi 5.0 on this server.  When the installation completed and the server rebooted, it did not boot into the ESXi where I can modify the IP address and VLAN.  Instead, I get this string of text after the initial boot sequence that is shown in the attachment.  I get a command prompt that says Shell> Not sure why I cannot boot properly in ESXi 5.0.  Thanks!  Paul

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Problem with booting to VMware ESXi 5.0

Hi Paul,

Looks like you are booting to the EFI shell. What is the boot policy that you have configured on that server service profile? It should look like the one below.  If this is an issue with the boot order, you should be able to type "EXIT" and then enter on the EFI shell to exit out of the prompt. If your boot policy is like the one below and you are still having this problem, try to decommission and re-ack the blade.

Let me know if this helps.

4 REPLIES
Cisco Employee

Re: Problem with booting to VMware ESXi 5.0

Hi Paul,

Looks like you are booting to the EFI shell. What is the boot policy that you have configured on that server service profile? It should look like the one below.  If this is an issue with the boot order, you should be able to type "EXIT" and then enter on the EFI shell to exit out of the prompt. If your boot policy is like the one below and you are still having this problem, try to decommission and re-ack the blade.

Let me know if this helps.

New Member

Re: Problem with booting to VMware ESXi 5.0

Thanks for answering this so quickly. 

I typed EXIT and that solved it! 

Paul

Cisco Employee

Re: Problem with booting to VMware ESXi 5.0

Great, I am glad this worked. Please if I answered your questions don't forget to accept it so other people don't reply to it.

New Member

Hi everyone,

Hi everyone,

I meet this problem also. Always I restart my server it is will appear this shell need to type command (exit).  I am using UCS C460 M4 that I had installed ESXi 5.5. Can someone advice me how to disable this case? (  I am using Raid 1)

Best regards,

Mr.Sokhom

3585
Views
5
Helpful
4
Replies