Does anyone know how to reset a UCS system to factory defaults? We have a UCS lab at the office and we need to be able to reset everything back to factory defaults so that multiple people can learn how to build a UCS system from the ground up.
You may only need to reset the 6120 as the chassis itself do not contain too much information, of course, is recommend to format all the local HDD if you are not performing SAN boot environment in your test.
You can do this from the CLI by SSH to the 6120 switches.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...