I've been trying to figure out how I can check what VLANs I have assigned to each service profile through CLI. I have no trouble viewing this through the GUI but there's just so many clicks to verify each server (10) with its NICS (2).
Anyone know how this is achieved?
And yes, I have configured vNIC Policys with VLANs mapped to them for the last couple of blades but I haven't had the chance to change this settings on my first 10 profiles =).
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...