05-22-2012 11:48 PM - edited 03-01-2019 10:25 AM
Hi all,
We are in time zone EST (Australia Sydney).
We just upgraded our ucs system to 2.02q and found the UCS clock is 1 hour fast than before.
As attached shows,we have not changed the timezone configuration after upgrade.
I logged in NXOS of UCS and i found the following configuration about timezone:
UCS-A(nxos)# show running-config | inc clock
clock timezone EST 10 0
clock summer-time EST 4 Sunday March 02:00 5 Sunday October 03:00 60
Above summer-time config is wrong to me.
In Australia:
Daylight Saving Time begins at 2am on the first Sunday in October and ends at 2am (which is 3am Daylight Saving Time) on the first Sunday in April.
Anybody from cisco can confirm it is firmware bug or not?
Best Regards
Solved! Go to Solution.
05-23-2012 04:43 AM
David,
I am able to re-create the problem in the lab. When it asks for confirmation, it displays the correct time but after we commit the changes, system is configured with +1 hour of the suggested time stamp.
-------------------------------------------------------------------
/system/services# set timezone
Therefore timezone 'Australia/Sydney' will be set.
Local time is now: Wed May 23 21:01:41 EST 2012.
Universal Time is now: Wed May 23 11:01:41 UTC 2012.
Is the above information OK?
1) Yes
2) No
#? 1
/system/services* # commit-buffer
/system/services # show clock
Wed May 23 22:02:10 EST 2012 <<<<======= Incorrect time
/system/services # connect nxos
(nxos)# show run | i clock
clock timezone EST 10 0
clock summer-time EST 4 Sunday March 02:00 5 Sunday October 03:00 60 <<<=== Incorrect Daylight savings description
----------------------------------------------
I have submitted following defect to track this issue.
It will take a while to get published on external website.
Please open a TAC service request and upload UCSM tech support bundle to it.
As a work around, we need to manually configure the time on FI.
scope system
scope services
set clock ?
Padma
05-23-2012 04:43 AM
David,
I am able to re-create the problem in the lab. When it asks for confirmation, it displays the correct time but after we commit the changes, system is configured with +1 hour of the suggested time stamp.
-------------------------------------------------------------------
/system/services# set timezone
Therefore timezone 'Australia/Sydney' will be set.
Local time is now: Wed May 23 21:01:41 EST 2012.
Universal Time is now: Wed May 23 11:01:41 UTC 2012.
Is the above information OK?
1) Yes
2) No
#? 1
/system/services* # commit-buffer
/system/services # show clock
Wed May 23 22:02:10 EST 2012 <<<<======= Incorrect time
/system/services # connect nxos
(nxos)# show run | i clock
clock timezone EST 10 0
clock summer-time EST 4 Sunday March 02:00 5 Sunday October 03:00 60 <<<=== Incorrect Daylight savings description
----------------------------------------------
I have submitted following defect to track this issue.
It will take a while to get published on external website.
Please open a TAC service request and upload UCSM tech support bundle to it.
As a work around, we need to manually configure the time on FI.
scope system
scope services
set clock ?
Padma
05-24-2012 04:15 PM
Thank you very much!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: