Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SuSe Linux 11 on B200

Hi,

Has anyone installed SuSe Linux 11.00 on a B200 M2 blade? According to the UCS compatibility matrix, it is supported, but we are unable to get network connectivity. We have managed to carry out a SAN install & are able to boot of it, but cannot get network connectivity. We are using the Palo card & we can see eth0 & eth1 under YAST, cannot connect out.

I did download drivers for the Nic from the support site, but it only support SLES 11.00 SP1.

Any pointers/suggestions?

Thanks

Kassim

1 REPLY
New Member

SuSe Linux 11 on B200

Hi All,

bit of an update. we have got nic connectivity now (misconfig on the UCS side). the question i now have is, does anyone know of any potential issues with using the built in drivers (enic & fnic) ? has anyone done such an install & where there any issues?

Thanks

399
Views
0
Helpful
1
Replies