Has anyone installed SuSe Linux 11.00 on a B200 M2 blade? According to the UCS compatibility matrix, it is supported, but we are unable to get network connectivity. We have managed to carry out a SAN install & are able to boot of it, but cannot get network connectivity. We are using the Palo card & we can see eth0 & eth1 under YAST, cannot connect out.
I did download drivers for the Nic from the support site, but it only support SLES 11.00 SP1.
bit of an update. we have got nic connectivity now (misconfig on the UCS side). the question i now have is, does anyone know of any potential issues with using the built in drivers (enic & fnic) ? has anyone done such an install & where there any issues?
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...