Has anyone installed SuSe Linux 11.00 on a B200 M2 blade? According to the UCS compatibility matrix, it is supported, but we are unable to get network connectivity. We have managed to carry out a SAN install & are able to boot of it, but cannot get network connectivity. We are using the Palo card & we can see eth0 & eth1 under YAST, cannot connect out.
I did download drivers for the Nic from the support site, but it only support SLES 11.00 SP1.
bit of an update. we have got nic connectivity now (misconfig on the UCS side). the question i now have is, does anyone know of any potential issues with using the built in drivers (enic & fnic) ? has anyone done such an install & where there any issues?
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...