Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Swapping local disks amongst different UCS blades

Hi all,

Most of our blades ( B230 M2s) are diskless and they boot from SAN. However i have a specific requirement where it is required to boot from local disk.

I do not have any disks in the B230M2 disk slots but i do have some B200M1 blades which have a couple of 146GB SAS drives.

If i just remove these HDDs from B200M1 and put then in the B230 M2 disk slot, would it break anything. Where do i find disk compatibility information? Any advise.

Drive details are as follows on a B200M1

Disk details.jpg

thanks.

Everyone's tags (4)
1 REPLY
Cisco Employee

Swapping local disks amongst different UCS blades

You can find this information in the spec sheet of these blades (See Below)

B200 M2  (page 14 table 5)

http://www.cisco.com/en/US/prod/collateral/ps10265/ps10280/spec_sheet_c17-644236.pdf

Cisco UCS B230 M2 Blade Server  (page 13 table 5)

http://www.cisco.com/en/US/prod/collateral/ps10265/ps10280/spec_sheet_c17-665957.pdf

257
Views
0
Helpful
1
Replies
CreatePlease to create content